Are you sure you want 8 ft lengths?

For the lowest shipping cost, we suggest 6 ft or shorter when possible. 8 ft lengths add substantially to UPS and FedEx shipping charges.

Full lengths are quoted by phone

We only sell short lengths online. For full mill lengths of 20–24 ft, please call us for a quote and we'll price the pipe and freight together.

Call 1-800-METPIPE

Mon–Fri, 8am–4pm ET

2" pipe is quoted by phone

2" aluminum pipe isn't sold online. It's available by quote only, in cut or full mill lengths. Call us and we'll price the pipe and freight together.

Call 1-800-METPIPE

Mon–Fri, 8am–4pm ET

 Skip to main content

Authorized Hollaender® distributor Made in the USA

Order by phone: 1-800-METPIPE

About the #30A

The #30A holds a pipe end against the side of a continuous pipe, offset from its center line. Use it where a branch needs to sit beside a post rather than in line with it.

Like every Nu-Rail® fitting, it's cast from corrosion-resistant 535 aluminum-magnesium alloy and locks onto standard pipe with set screws. No welding, no threading, just a hex key. Loosen the screws and you can reposition it or take the whole structure apart later.

Where it's used

  • Offset rails and shelf supports
  • Braces beside posts
  • Display frames

Sizes & options

Available for 3/4" to 1-1/2" IPS pipe. We stock the standard mill finish. Anodized fittings and stainless steel set screws for harsh environments are available on request; call 1-800-METPIPE.

Specifications

Figure
#30A
Fits
3/4" to 1-1/2" IPS pipe
Casting
ASTM B26
Alloy
ASTM B179 535 Aluminum/Magnesium Alloy
Finish
Bright Burnished Mill Finish
Fastening
Set screw, hex key (no welding or threading)
  • Slip-on

Sizes & pricing

Item # Pipe size SKU Price Availability Add to cart
#30A-5 3/4" 45345 $29.18 In stock
#30A-6 1" 8796 $34.18 In stock
#30A-7 1-1/4" 33642 $40.99 In stock
#30A-8 1-1/2" 8864 $44.76 In stock

Buying several sizes? Add each one right from this table. For job-site quantities, call 1-800-METPIPE.

How it goes together

  1. Slide it on Cut pipe to length and slip the fitting over the end. No threading.
  2. Position it Slide to height and set the angle before you lock it.
  3. Tighten the set screws Lock it with a hex key. Loosen it to adjust or take it apart later.
See all swivels